The embedded RP feature that works for IPv6 multicast is a cool trick that embeds the IPv6 address of the RP within the IPv6 multicast group address. By doing this, multicast enabled routers can extract the RP address just by looking at the multicast group address and use it for a shared tree.
11/21/2018 · ipv6 pim rp embedded. To enable embedded rendezvous point (RP) support in IPv6 Protocol Independent Multicast (PIM), use the ipv6 pim rp-embedded command in global configuration mode. To disable embedded RP support, use the no form of this command. ipv6 pim [ vrf vrf-name] rp embedded . no ipv6 pim [ vrf vrf-name] rp embedded . Syntax Description, 1/19/2018 · IPv6 PIM provides embedded RP support. Embedded RP support allows the device to learn RP information using the multicast group destination address instead of the statically configured RP . For devices that are the RP , the device must be statically configured as the RP.
1/19/2018 · PIM Allow RP . This module describes how to configure the PIM Allow RP feature in IPv4 or IPv6 networks for inter-connecting Protocol Independent Multicast ( PIM) Sparse Mode (SM) domains with different rendezvous points (RPs). PIM Allow RP enables the receiving device to use its own RP to create state and build shared trees when an incoming (*, G) …
3/28/2010 · E mbedded RP, with IPv6 multicast, is a very cool trick. It simply embeds the RP IPv6 address as part of the multicast group address. This way, when a multicast router sees the group address, it can extract the RP and begin to use it for the shared tree immediately. The only thing that has to be hard coded on a router is to tell the RP that he is …
IP Multicast: PIM Configuration Guide – PIM Allow … – Cisco, RFC 3956 The RP Address in IPv6 Multicast Address November 2004 1.4.Terminology Embedded – RP behaves as if all the members of the group were intra- domain to the information distribution. However, as it gives a solution for the global IPv6 multicast Internet, spanning multiple administrative domains, we say it is a solution for inter-domain multicast.
9/28/2019 · Verge Documentation – English// IPv6 PIM Commands. Angora Networks Product Support Portal. ipv6 pim accept-register. To configure a candidate rendezvous point ( RP ) router to filter Protocol Independent Multicast ( PIM ) register messages, use the ipv6 pim accept-register command in global configuration mode.To disable this function, use the no form of this command.
On an IPv6 PIM -SM network, the embedded RP function is enabled on each device by default. When a device receives a multicast packet sent to a multicast group, it can obtain RP information from the group address. The devices with the embedded RP function do not need to know the mapping between RPs and group addresses beforehand.
